2025-01-13

围板外件下部

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Flow Form Rivets, S08

    or Flow Form Rivets, S18

  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. 用聚氨酯填充围板外件面板和围板外件下部面板(以红色表示)之间的间隙。
  6. 聚氨酯固化后,使用接缝密封剂全面填充接缝。
  7. Perform any necessary post-repair operations.