2024-07-10
前排座位总成
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY - SHOTGUN（前排座位总成） |
注 前排座位总成维修零件可能包括安装在组件前下方的加固件支架。如果前排座位总成维修零件不包括此加固件支架，则会安装加固件板以在该区域提供支撑。 
|
| 1 | 前排座位总成加固件板维修（前排座位加固件板） |
|
| 12 |
Structural Bulb Rivet, 6.5 mm
|
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or 
Factory Spot Welds
-
如果前排座位总成维修零件包括加固件支架：
Prepare for installation.
or Structural Bulb Rivets, 6.5 mm
注如果前排座位总成维修零件包括加固件支架，则不会安装加固件板，并且可将其弃用或退回。
-
如果前排座位总成维修零件不包括加固件支架：
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
如果前排座位总成维修零件不包括加固件支架：
准备安装加固件支架。
GMA Weld
-
如果前排座位总成维修零件不包括加固件支架：
Perform GMA welding.
GMA Weld
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.注Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.
-
安装挡泥板支架。
- Perform any necessary post-repair operations.