轮罩加长板（后部）
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | MY Asy,WheelHouse Outer,SVC E-COATED（轮罩外件） |
|
| 2 | ||
| 10 | ||
| 2 | ||
| 1 | ||
| 2 | Tesla 零件号 1008833-01-A。 | |
| 2 | Tesla 零件号 1006628-01-A。 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or 
Factory Spot Welds
-
从 MY Asy,WheelHouse Outer,SVC E-COATED 维修零件上拆下轮罩后部加长板组件。
-
Prepare for installation.
or 
Rivets, 4.8 mm
- A = 43 毫米
- B = 7 毫米
or 
High Strength Structural Rivets, 6.5 mm
or 
Aluminum Plug Welds
注对于此塞焊焊缝，在指定位置钻一个 6 毫米的孔。
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
将螺栓拧紧至 22 Nm。注请务必切割重低音扬声器下方的 NVH 泡沫，以留出铆钉间隙。
-
Perform GMA welding.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.注Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.
- Perform any necessary post-repair operations.
