2024-10-17

后围外件

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	MY Rear Quarter Outer Rr,RH SVC E-COATED（后围外件）
16	Structural Bulb Rivet, 6.5 mm
1	Flow Form Rivet S18
5	Flow Form Rivet S38

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

仅限 LH 组件维修：拆卸充电端口电子控制单元支架。
拆卸转向部分下部。
Remove the original component.

or Factory SPRs

or Factory Spot Welds
Prepare for installation.

注
A red X indicates a location where a factory-installed fastener is not being replaced.

or Structural Bulb Rivets, 6.5 mm

or Flow Form Rivets, S18
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
安装转向部分下部。
仅限 LH 组件维修：安装充电端口电子控制单元支架。
Install the fasteners as indicated.

or Flow Form Rivets, S38
Perform any necessary post-repair operations.