2026-11-06

Wheelhouse Insulator - Rear - RH (Remove and Replace)

校正代码 15300401 15300402 FRT 0.96 注意：除非本程序中另有明确规定，否则上文所列校正代码及相关 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅深入了解 FRT 及其创建方式。 注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。 注意：请参阅查看安全健康的作业规程。

警告
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-10-20: Updated the steps of removing the insulator by cutting it open.
  • 2025-12-01: Released new procedure.

拆卸

  1. Open all four doors and lower all four windows.
  2. Open the liftgate.
  3. Remove the subwoofer. See 重低音扬声器（拆卸和更换）.
  4. Release the clips (x2) that secure the RH body harness to the RH side trunk bulkhead.
  5. Release the RH body harness clip from the C-pillar and pull the harness backward to move it away from the body.
  6. Cut the RH rear wheelhouse insulator near the RH body harness to allow for the removal of the insulator.
  7. Remove the RH rear wheelhouse insulator from the vehicle.

安装

  1. Cut the RH rear wheelhouse insulator near the RH body harness to allow the harness to be routed into the insulator's opening hole.
  2. Install the RH rear wheelhouse insulator to the vehicle.
  3. Install the body harness back into position and secure the clip that attaches the RH body harness to the C-pillar.
  4. Secure the clips (x2) that attach the RH body harness on RH side trunk bulkhead.
  5. Install the subwoofer. See 重低音扬声器（拆卸和更换）.
  6. Close the liftgate.
  7. Raise all four windows and close all four doors.