后面板侧方总成（适用于 1 件式车底铸件）
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | MY Asy, Rear Panel Side, SVC E-COATED（后面板侧方总成） |
|
| 5 | ||
| 1 |
Structural Bulb Rivet, 6.5 mm
|
|
| 1 | ||
| 3 |
Bolt
|
Tesla 零件号 2007069。 注 保留这些螺栓，以便在安装保险杠梁时使用。这些螺栓将从车辆内侧穿过后纵梁端板安装在拆下螺柱的位置。 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
拆卸“面板总成 - 后”（请参阅维修手册程序）。
-
Remove the original component.
or 
Factory SPRs
or 
Factory Spot Welds
螺柱
-
Prepare for installation.
注A red X indicates a location where a factory-installed fastener is not being replaced.
or 
Installation Spot Welds
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform resistance spot
welding.
or Installation Spot Welds
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
-
安装“面板总成 - 后”（请参阅维修手册程序）。
- Perform any necessary post-repair operations.
