横梁密封磁盘（前）
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | PANEL - PLATTER SEALING CROSSMEMBER FRONT（横梁密封磁盘 – 前） |
|
| 1 | BUTYL FOIL PATCH 300X150x2MM（丁基胶箔补片） |
Tesla 零件号 1004969-00-A。 |
| 5 |
Structural Countersunk Rivet, 6.5 mm
|
|
| 8 |
Structural Bulb Rivet, 6.5 mm
|
|
| 9 |
Countersunk Rivet, 4.8 mm Long
|
|
| 5 |
Countersunk Rivet, 4.8 mm Short
|
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or 
Factory Spot Welds
或 
钻透原厂点焊焊缝
注在红色突出显示区域中钻除点焊焊缝时，请使用 8 毫米钻头。在红色突出显示区域之外钻除点焊焊缝时，请确保使用的钻头能钻出一个大小合适的孔，以便用紧固件代替点焊。
-
Prepare for installation.
注A red X indicates a location where a factory-installed fastener is not being replaced.注一些铆钉的安装位置已偏移，以避开紧固件已拆下但尚未更换的位置。
Reference
Line/Point
or Structural Bulb Rivets, 6.5 mm
or Structural Countersunk Rivets, 6.5 mm
or Countersunk Rivets, 4.8 mm Short
or Countersunk Rivets, 4.8 mm Long
- A = 16 毫米
- B = 13 毫米
- C = 36 毫米
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
按指示安装丁基胶箔补片，以覆盖安装好的紧固件。
- Perform any necessary post-repair operations.