Front Frame Rail
Correction code:
10101023002
10101022902
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Depending on the damage to this component, it may be possible to repair this component. Refer to Front Frame Rail Cap Repair Guidelines for more information.
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY - MX Member Rail Frt Complete (Front Frame Rail) | |
| 8 | Bolt, Torx-head , M8x34 | Tesla part number 1022448-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Fender Assembly - Front - LH (Remove and Replace).
- Remove the Bracket - Headlight - LH (Remove and Replace).
- Remove the Active Damper - Front - LH (Remove and Replace).
- Remove the Carrier - Front End (Remove and Replace).
- LH component only: Remove the Horn - Low Tone (Remove and Replace).
- LH component only: Remove the Horn - High Tone (Remove and Replace).
- LH component only: Remove the Reservoir - Windshield Washer (Remove and Replace).
- RH component only: Remove the Compressor - Air Suspension (Remove and Replace).
- RH component only: Remove the Bracket - Carrier - Compressor - Air Suspension (Remove and Replace).
- LH component only: Remove the A/C Compressor (Remove and Replace).
- RH component only: Remove the Module - Body Controller - Front (Remove and Replace).
-
Remove the original component.
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque all bolts to 30 Nm.
- Perform any necessary post-repair operations.
- RH component only: Install the Module - Body Controller - Front (Remove and Replace).
- LH component only: Install the A/C Compressor (Remove and Replace).
- RH component only: Install the Bracket - Carrier - Compressor - Air Suspension (Remove and Replace).
- RH component only: Install the Compressor - Air Suspension (Remove and Replace).
- LH component only: Install the Reservoir - Windshield Washer (Remove and Replace).
- LH component only: Install the Horn - High Tone (Remove and Replace).
- LH component only: Install the Horn - Low Tone (Remove and Replace).
- Install the Carrier - Front End (Remove and Replace).
- Install the Active Damper - Front - LH (Remove and Replace).
- Install the Bracket - Headlight - LH (Remove and Replace).
- Install the Fender Assembly - Front - LH (Remove and Replace).