Hinge Pillar Inner
Correction code:
10100130502
10100129302
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | Asy-Frt Hinge Plr Inr Fastener (Hinge Pillar Inner) |
|
| LH 3 or RH 1 |
High Strength Structural Rivet, 6.5 mm
|
|
| LH 2 or RH 4 |
Structural Bulb Rivet, 6.5 mm
|
|
| 3 |
Structural Countersunk Rivet, 6.5 mm
|
|
| 3 |
Flow Form Rivet S18
|
|
| 1 rivet needed; order 10 rivets |
Flow Form Rivet S48
|
|
| 6 |
Flow Form Rivet S58
|
|
| 1 |
Bolt
,
M6X18,[88],G0110,MAT |
Tesla part number 1006529-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the Hinge Pillar Reinforcement.
-
Remove the original component.
or 
Factory Spot Welds
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
or High Strength Structural Rivets, 6.5 mm
or Structural Bulb Rivets, 6.5 mm
or Structural Countersunk Rivets, 6.5 mm
or Flow Form Rivets, S58
- A = 10 mm.
- B = 36 mm.
or Flow Form Rivets, S18
- C = 49 mm.
- D = 35 mm.
or Bolts
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolt to 12 Nm.
-
Install the Hinge Pillar Reinforcement.
-
Install the fasteners as indicated.
-
Install the A-Pillar Outer Bracket (Lower).
- Perform any necessary post-repair operations.
