2026-06-23

D-Pillar Inner Reinforcement

Correction code: 10101915502 10101915002 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASY - D-PILLAR INR REINF (D-Pillar Inner Reinforcement)
9	Structural Bulb Rivet, 6.5 mm
8	Flow Form Rivet S18
3	Flow Form Rivet S28
4	Flow Form Rivet S38

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
Remove the Fascia Assembly - Rear (Remove and Install).
Remove the Glass - Rear Quarter - LH (Remove and Install).
Remove the Trim - Liftgate Trough - LH (Remove and Replace).
Remove the Trim - Liftgate Trough - Center (Remove and Replace).
Remove the Seal - Liftgate (Remove and Replace).
Remove the Taillight - LH (Global) (Remove and Replace).
Remove the Fascia Assembly - Rear (Remove and Install).
Remove the Taillight - RH (Remove and Replace).
Remove the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
Remove the Glass - Rear Quarter - LH (Remove and Install).
Remove the Trim - Liftgate Trough - LH (Remove and Replace).
Remove the Trim - Liftgate Trough - Center (Remove and Replace).
Remove the Seal - Liftgate (Remove and Replace).
Remove the original component.

or Factory Spot Welds

or Drill through factory spot welds
Prepare for installation.

or Structural Bulb Rivets, 6.5 mm

or Flow Form Rivets, S18

or Flow Form Rivets, S28

or Flow Form Rivets, S38
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the Enclosure Attachment Bracket (Upper).
Perform any necessary post-repair operations.
Install the Seal - Liftgate (Remove and Replace).
Install the Trim - Liftgate Trough - Center (Remove and Replace).
Install the Trim - Liftgate Trough - LH (Remove and Replace).
Install the Glass - Rear Quarter - LH (Remove and Install).
Install the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
Install the Taillight - RH (Remove and Replace).
Install the Fascia Assembly - Rear (Remove and Install).
Install the Taillight - LH (Global) (Remove and Replace).
Install the Seal - Liftgate (Remove and Replace).
Install the Trim - Liftgate Trough - Center (Remove and Replace).
Install the Trim - Liftgate Trough - LH (Remove and Replace).
Install the Glass - Rear Quarter - LH (Remove and Install).
Install the Fascia Assembly - Rear (Remove and Install).
Install the Insulator - Wheelhouse - Rear - LH (Remove and Replace).