2026-09-01

Rear Quarter Outer (Lower) (Vehicles Built Through February 14, 2022)

Correction code: 10100141002 10100141102 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASY - PNL REAR QTR OTR LWR (Rear Quarter Outer - Lower)
29	Structural Bulb Rivet, 6.5 mm
1	Flow Form Rivet S08
1	Flow Form Rivet S18

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Garnish - Fender - Rear - LH (Remove and Replace).
Remove the Assembly - Trailer Hitch (Remove and Replace).
Remove the Bracket - Rear Wing - LH (Remove and Replace).
Remove the Air Extractor - Rear - Outer - LH (Remove and Replace).
Remove the Wheel Arch Liner - Rear - LH (Remove and Replace).
LH component only: Remove the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
RH component only: Remove the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
Remove the original component.
or Factory Spot Welds
or Drill through factory spot welds
Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
Prepare for installation.

Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.

or Structural Bulb Rivets, 6.5 mm

or Flow Form Rivets, S08

or Flow Form Rivets, S18
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Fill the gap between the Quarter Outer panel and the Quarter Outer Lower panel (indicated in red) with urethane.
Once the urethane has cured, use seam sealer to completely fill the seam.
Perform any necessary post-repair operations.
RH component only: Install the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
LH component only: Install the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
Install the Wheel Arch Liner - Rear - LH (Remove and Replace).
Install the Air Extractor - Rear - Outer - LH (Remove and Replace).
Install the Bracket - Rear Wing - LH (Remove and Replace).
Install the Assembly - Trailer Hitch (Remove and Replace).
Install the Garnish - Fender - Rear - LH (Remove and Replace).