Rear Frame Rail Assembly
Correction code:
10101820302
10101820202
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASSY-MEMBER-RECT RAIL EXTRUSION RR (Rear Frame Rail Assembly) | |
| 5 (per side) | Bolt, Torx-head , M8 | Tesla part number 1022448-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Panel - Aero Shield - Front (Remove and Replace).
- Remove the Panel - Aero Shield - Rear (Remove and Replace).
- Remove the Insulator - Motor Bay - Rear (7 Seat) (Remove and Replace).
- Remove the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Remove the Panel - Aero Shield - Front (Remove and Replace).
- Remove the Panel - Aero Shield - Rear (Remove and Replace).
- Remove the Insulator - Motor Bay - Rear (7 Seat) (Remove and Replace).
- Remove the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
-
Remove the Rear Panel (Vehicles Built Through May 21, 2024).
-
Remove the Rear Trunk Floor Panel Extension.
-
Remove the original component.
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolts to 30 Nm.
-
Install the Rear Trunk Floor Panel Extension.
-
Install the Rear Panel (Vehicles Built Through May 21, 2024).
- Perform any necessary post-repair operations.
- Install the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
- Install the Insulator - Motor Bay - Rear (7 Seat) (Remove and Replace).
- Install the Panel - Aero Shield - Rear (Remove and Replace).
- Install the Panel - Aero Shield - Front (Remove and Replace).
- Install the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Install the Insulator - Motor Bay - Rear (7 Seat) (Remove and Replace).
- Install the Panel - Aero Shield - Rear (Remove and Replace).
- Install the Panel - Aero Shield - Front (Remove and Replace).