Rear Header Upper
Correction code:
10102705702
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY-RR HEADER (Rear Header Upper) | |
| 31 | Flow Form Rivet S18 | |
| 8 | Flow Form Rivet S38 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Trim - Liftgate Trough - LH (Remove and Replace).
- Remove the Trim - Liftgate Trough - Center (Remove and Replace).
- Remove the Seat Assembly - 2nd Row - LH (5 Seat) (Remove and Replace).
- Remove the Seal - Liftgate (Remove and Replace).
- Remove the Liftgate (Remove and Replace).
- Remove the Applique - Roof - Rear (Remove and Replace).
- Remove the Carrier - Applique - Center Spine - LH (Remove and Replace).
- Remove the Door Assembly - Rear Upper - LH (Remove and Replace).
- Remove the Seal - Body - Side - Rear - Primary - LH (Remove and Replace).
- Remove the Bracket - Racetrack - Header - Rear - LH (Remove and Replace).
- Remove the Seat Assembly - 2nd Row - RH (5 Seat) (Remove and Replace).
- Remove the Seat Assembly - 3rd Row (Remove and Replace).
- Remove the Insulator - Motor Bay - Rear (5 Seat) (Remove and Replace).
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Insulator - Motor Bay - Rear (5 Seat) (Remove and Replace).
- Install the Seat Assembly - 3rd Row (Remove and Replace).
- Install the Seat Assembly - 2nd Row - RH (5 Seat) (Remove and Replace).
- Install the Bracket - Racetrack - Header - Rear - LH (Remove and Replace).
- Install the Seal - Body - Side - Rear - Primary - LH (Remove and Replace).
- Install the Door Assembly - Rear Upper - LH (Remove and Replace).
- Install the Carrier - Applique - Center Spine - LH (Remove and Replace).
- Install the Applique - Roof - Rear (Remove and Replace).
- Install the Liftgate (Remove and Replace).
- Install the Seal - Liftgate (Remove and Replace).
- Install the Seat Assembly - 2nd Row - LH (5 Seat) (Remove and Replace).
- Install the Trim - Liftgate Trough - Center (Remove and Replace).
- Install the Trim - Liftgate Trough - LH (Remove and Replace).