2026-08-09

降噪衬垫 - 电机舱 - 后(拆卸和更换)

校正代码 120102022.10 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

拆卸

  1. Remove the rear subframe. See 副车架总成 - 后(拆卸和安装).
  2. Remove the clips (x6) that attach the rear motor bay noise absorber to the body, and then remove the noise absorber from the vehicle.

安装

安装程序与拆卸程序相反。