2025-09-11
Blower - Backrest - Driver Seat (Model YL) (Remove and Replace)
Correction code
13010201002
FRT
0.18
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the driver seat back shell. See Shell - Seat Back - Driver Seat (Model YL) (Remove and Replace).
-
Disconnect the electrical connector
from the driver seat back blower.
-
Rotate the seat back blower clockwise
to remove it from the seat.
Install
-
Rotate the seat back blower counter-clockwise to install it onto the seat.
-
Connect the electrical connector to the driver seat back blower.
- Install the driver seat back shell. See Shell - Seat Back - Driver Seat (Model YL) (Remove and Replace).