2025-09-11

Motor - Seat Track - 1st Row Seat (Model YL) (Remove and Replace)

Correction code 13010201302 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Remove the driver seat assembly. See 1st Row Seat- LH (Remove and Install).
  2. Maneuver the seat to gain access to the underside.
  3. Disconnect the electrical harness from the LH seat track motor connector.
  4. With assistance, remove harness clips (x3) from seat track motor bridge assembly.
  5. Remove and discard the outboard bolts (x2) that attach the seat track to the seat cushion frame.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  6. With assistance, release the outboard seat track from the track motor bridge.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pry up on the track motor bridge tab and slide the outboard seat track away to release.
  7. Release the track motor bridge from the inboard seat track, and then remove the motor bridge from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pry up on the track motor bridge tab and slide the track motor bridge away from the inboard track.

Install

  1. With assistance, install the LH front seat track motor bridge assembly to the inboard seat track.
    Informational PurposesAn informational icon, calling your attention
    Note
    The track motor cable is keyed square and must be aligned with the inboard track. Turn the cable by hand to align as needed. Slide the track motor bridge into the inboard track till it is fully and securely seated.
  2. Install the outboard seat track to the LH front seat track motor bridge assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    The track motor cable is keyed square and must be aligned with the inboard track. Turn the cable by hand to align as needed. Slide the track motor bridge into the inboard track till it is fully and securely seated.
  3. Connect the electrical harness to the LH seat track motor connector.
  4. With assistance, install the harness clips (x3) to the LH front seat track motor bridge assembly.
  5. Install new outboard bolts (x2) that attach the seat track to the seat cushion frame.
    38 Nm (28.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  6. Position the driver seat assembly in the upright position.
  7. Install the driver seat assembly. See 1st Row Seat- LH (Remove and Install).