2025-09-12
Bumper Block - Liftgate (Liftgate Side) - LH (Model YL) (Remove and Replace)
Correction code
11332901202
FRT
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the LH lower side cover. See Cover - Lower Side - Liftgate - LH (Model YL) (Remove and Replace).
-
Rotate the LH liftgate belt bumper
block counter-clockwise to release, and then remove and discard the bumper block.
Install
-
Rotate a new LH liftgate belt bumper block clockwise to install the bumper block to
the liftgate.
- Install the LH lower side cover. See Cover - Lower Side - Liftgate - LH (Model YL) (Remove and Replace).
-
Verify the flushness from the liftgate to the rear fascia assembly, and adjust as
necessary.
NoteRefer to Toolbox article 8199800 for additional information on bump stop adjustment.