2025-12-19

Reflex Lens - Rear - LH (Model Y L) (Remove and Replace)

Correction code 17400406002 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-12-18: Released new procedure.

Remove

  1. Open the liftgate.
  2. Apply tape to the RH rear quarter panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use masking tape to protect the working area.
  3. Gently pry from the side to release the clips (x3) that attach the RH reflex lens to the vehicle, then remove and discard the RH reflex lens.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any damaged clips to prevent NVH issues.

Install

  1. Place the RH reflex lens onto the vehicle and press gently to fully seat the clips (x3).
  2. Adjust the RH reflex to ensure it is flush with the rear quarter panel.
    0.7 Nm (6 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
  3. Close the liftgate.