2025-09-11

Blower - Cushion - 2nd Row Seat - LH (Model YL) (Remove and Replace)

Correction code 13020201302 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the seat ECU mounting bezel and seat module assembly from the LH 2nd row seat. See ECU Mounting Bezel - 2nd Row Seat - LH (Model YL) (Remove and Replace).
  2. Disconnect the LH 2nd row seat cushion blower connector.
  3. Remove the LH 2nd row seat cushion blower from its mounting location on the seat by disengaging the tabs (x2) and then pulling it outward.

Install

  1. Position the LH 2nd row seat cushion blower at its mounting location on the seat, push it inward, then engage the tabs (x2) to install it in place.
  2. Connect the LH 2nd row seat cushion blower connector.
  3. Install the seat ECU mounting bezel and seat module assembly to the LH 2nd row seat. See ECU Mounting Bezel - 2nd Row Seat - LH (Model YL) (Remove and Replace).