2025-09-11

B-Cover - Center Inner - 3rd Row (Model YL) (Remove and Replace)

Correction code 13090101602 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the 3rd row center outer B-cover. See B-Cover - Center Outer - 3rd Row (Model YL) (Remove and Replace).
  2. Remove the clips (x2) that attach the 3rd row center inner B-cover to the seat frame assembly.
  3. Remove the screw that attaches the 3rd row center inner B-cover to the seat frame assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  4. Remove the 3rd row LH buckle harness clips (x3) from the center inner B-cover.
  5. Remove the trunk tub. See Trunk Tub (Model YL) (Remove and Replace).
  6. Release the tabs (x4) to remove the 3rd row center inner B-cover from the seat frame assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently move the B-cover downward, and then use a clip prytool to push the side trim panel outward to release the B-cover.

Install

  1. Secure the tabs (x4) to install the 3rd row center inner B-cover to the seat frame assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently install the B-cover downward, and then use a clip prytool to push the side trim panel outward to install.
  2. Install the trunk tub. See Trunk Tub (Model YL) (Remove and Replace).
  3. Install the 3rd row LH buckle harness clips (x3) to the center inner B-cover.
  4. Install the screw that attaches the 3rd row center inner B-cover to the seat frame assembly.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  5. Install the clips (x2) that attach the 3rd row center inner B-cover to the seat frame assembly.
  6. Install the 3rd row center outer B-cover. See B-Cover - Center Outer - 3rd Row (Model YL) (Remove and Replace).