2026-04-20

Correction code 1308021402 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-01-26: Released new procedure.

Remove

  1. Remove assembly harness from 2nd row LH seat back. See 2nd Row Seat Back Harness - LH (7 Seater) (Remove and Replace).
  2. Release 2nd row LH seatback cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull material downward to release.
  3. Remove seatback cover from foam.
    Informational PurposesAn informational icon, calling your attention
    Note
    If LH seat that is not being repaired does not have ISOFIX flag for child locks, the seat covers will also require replacement.
  4. Remove seat back heat pad.
    Informational PurposesAn informational icon, calling your attention
    Note
    Guide harness through seat back shell.

Install

  1. Install seatback cover onto foam.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull material downward to attach, Ensure material is distributed correctly on visible face.
  2. Secure 2nd row LH seatback cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull material downward to secure tabs and align material.
  3. Install assembly harness to 2nd row LH seat back. See 2nd Row Seat Back Harness - LH (7 Seater) (Remove and Replace).
  4. Run ODIN routine PROC_ICE_X_ENTER-SERVICE-MODEvia Toolbox:(link)
  5. Run ODIN routine
  6. Run ODIN routine PROC_VCLEFT_X_2R-SEAT-RECLINE-CALIBRATIONvia Service Mode:Low Voltage ➜ Second Row Seats ➜ Calibratevia Toolbox:(link)
  7. Run ODIN routine PROC_ICE_X_EXIT-SERVICE-MODEvia Toolbox:(link)
  8. Close all four doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    If LV is powered up then unlatch rear doors before closing.