2026-11-11

Jumpstart Vehicle (Restore)

Correction code 17000008 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-11-11: Released new procedure.

Procedure

  1. Release the tabs (x4) that secure the tow hook cover.
    Tip
    Release upper portion of cover first
  2. Pull the hood manual release straps.
  3. Open the hood and lift it manually.
  4. Remove the HEPA filter. See Filter - HEPA (Remove and Replace).
  5. Install the tow hook cover.
    Tip
    Engage lower portion of cover first
  6. Remove the 12V battery positive terminal cover.
  7. Connect the jumper leads to the 12V battery, then jump the vehicle per jumper manufacturer instructions.
    Note
    For XP-20 jump starter, press the power button, then press and hold "Bypass" to jump-start