2026-07-06

Harness - Rear Door - Lower - LH (Remove and Replace)

Correction code 17102812 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-06-24: Released new procedure.

Remove

  1. Remove the LH rear door closeout panel. See Closeout Panel - Door - Rear - LH (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Disconnect 12 V power regardless of the vehicle build date.
  2. Remove bolts securing LH actuator and pull actuator up to gain access, disconnect cinch actuator
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, 3x nuts, 10mm, 3 Nm
  3. Disconnect window regulator motor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  4. Remove speaker from LH rear door
    Informational PurposesAn informational icon, calling your attention
    Note
    4x bolts, T25, 4 Nm, 2x datums, 1x connector
  5. Disconnect LH falcon door close switch
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  6. Disconnect LH falcon door rear pinch sensor connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  7. Disconnect clip from LH lower latch cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip
  8. Remove LH lower latch cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x latching tab
  9. Disconnect LH lower latch connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  10. Disconnect LH falcon door front pinch sensor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  11. Disconnect LH ultrasonic sensor connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, Release locking tab, Do not use pry tool on tri pod
  12. Remove LH rear door lower harness
    Informational PurposesAn informational icon, calling your attention
    Note
    8x fasteners, 1x plug

Install

  1. Install LH rear door lower harness
    Informational PurposesAn informational icon, calling your attention
    Note
    8x clips, 1x plug
  2. Connect LH ultrasonic sensor harness connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, 1x clip, Engage locking tab after securing connect
  3. Connect LH outer door handle carrier connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  4. Connect LH front pinch sensor connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  5. Connect LH lower latch connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  6. Install LH lower latch cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x latching tab
  7. Attach clip to LH lower latch cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip
  8. Connect LH rear pinch sensor connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  9. Connect LH falcon door close switch connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  10. Install LH falcon door speaker
    Informational PurposesAn informational icon, calling your attention
    Note
    4x screws, T25, 4 Nm, 1x connector
  11. Connect and install LH cinch actuator
    Informational PurposesAn informational icon, calling your attention
    Note
    3x nuts, 10mm, 3 Nm
  12. Remove the LH rear door closeout panel. See Closeout Panel - Door - Rear - LH (Remove and Install).