2026-07-20

Door - Front - LH (Remove and Install)

Korrekturcode 10106001 0.42 HINWEIS: Sofern im Verfahren nicht ausdrücklich anders angegeben, spiegeln der obige Korrekturcode und die FRT den gesamten für die Durchführung dieses Verfahrens erforderlichen Aufwand wider, einschließlich der damit verbundenen Verfahren. Schichten Sie keine Korrekturcodes, wenn Sie nicht ausdrücklich dazu aufgefordert werden. HINWEIS: Unter Richtzeiten erfahren Sie mehr über FRTs und wie sie erstellt werden. HINWEIS: Siehe Persönlicher Schutz, um sicherzustellen, dass Sie die richtige persönliche Schutzausrüstung tragen, wenn Sie das folgende Verfahren durchführen. HINWEIS: Siehe für sichere und gesunde Arbeitsmethoden.

Ausbauen

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  4. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  5. Remove the middle A-Pillar trim panel. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  6. Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  7. Disconnect the LH front door electrical connectors from the LH body controller module.
  8. Release the electrical harness clip from the LH body controller module.
  9. Release the grommet, and then push the LH door electrical harness through the A-pillar bulkhead.
  10. Remove the bolt that attaches the LH front door check strap to the A-pillar.
    24 Nm (17.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Unbolting the door check allows the door to swing freely beyond opening limits.
  11. Use tape to mark the mounting locations of the door hinges on the LH front door.
  12. Loosen the hinge bolts, and then remove the lower bolts for each hinge.
    24 Nm (17.7 lbs-ft)
  13. Partially unthread the upper bolt for each hinge, and with assistance, lift the LH front door away from the vehicle.

Montieren

Informational PurposesAn informational icon, calling your attention
TIp
For instructions on how to align the front door, refer to .

Beim Einbauverfahren werden die Schritte des Ausbauverfahrens in umgekehrter Reihenfolge ausgeführt, mit folgender Ausnahme:

  • Partially thread the upper bolt for each hinge in the door so that the door can set on the hinges to install the lower bolt.
  • Apply touch up paint to painted fasteners that were removed and reinstalled during this procedure.