Commission the System After Powerwall and Solar Installation

  1. Close the AC circuit breaker for Powerwall 3and Gateway 3.
  2. Turn the Powerwall 3 switch ON.
  3. Launch the Tesla One app.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure Tesla One is updated to version 7.9.1 or greater, or install Tesla One if using for the first time.
  4. Navigate to Device Setup to begin commissioning.
  5. Select Scan and scan the Powerwall 3 QR label to connect to the TeslaPW Wi-Fi network.
  6. Address any alerts to complete commissioning. See the Powerwall 3 Device Setup commissioning guide for additional instructions.
    Informational PurposesAn informational icon, calling your attention
    Note
    The Backup Test can be performed during the Gateway 3 device update. There is no need to wait for the update to complete before performing the Backup Test.
  7. Leave the system running in Tesla One.
  8. Leave the Powerwall switch ON and the breaker CLOSED to enable charging.
    Informational PurposesAn informational icon, calling your attention
    Note
    The Powerwall 3 On / Off switch has a locking mechanism. When the switch is locked it cannot be turned on. See Powerwall 3 Switch Locking Mechanism for more information.