Divider Bar Reinforcement
Correction code:
10101921302,
10101921402
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
|
1 |
DIVIDER BAR (Divider Bar Reinforcement) |
|
| 4 | Structural Bulb Rivet, 6.5 mm | |
| 2 | Flow Form Rivet S28 | |
| 6 | Flow Form Rivet S38 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Seal - Body - Side - Rear - Primary - LH (Remove and Replace).
- Remove the Brightwork - Upper - LH (Remove and Replace).
- Remove the Glass - Body - Rear Quarter - LH (Remove and Install).
- Remove the Airbag - Curtain - LH (Remove and Replace).
-
Remove the original component.
- or Factory Spot Welds
- or Factory SPRs
-
Prepare for installation.
- Reference Line/Point
- or Structural Bulb Rivets, 6.5 mm A = 7 mm B = 27 mm C = 12 mm
- Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Airbag - Curtain - LH (Remove and Replace).
- Install the Glass - Body - Rear Quarter - LH (Remove and Install).
- Install the Brightwork - Upper - LH (Remove and Replace).
- Install the Seal - Body - Side - Rear - Primary - LH (Remove and Replace).