Dimensional Specifications

Lists the dimensions between known points on the vehicle for use in diagnosing vehicle damage.

Dimensional measurements are used as an aid for diagnosing vehicle damage and determining if structural repairs might be necessary to return the vehicle to specification.

Informational PurposesAn informational icon, calling your attention
Note
All measurements provided in this document are for reference only.

When taking measurements:

  • All measurements are in millimeters.
  • All marks, holes, slots, and fasteners are measured center-to-center.
  • All dimensions are symmetrical unless otherwise specified.
  • Point-to-point measurements are duplicated with tram bar pointers set at equal lengths.
  • Always calibrate the tracking gauge before measuring or after adjusting the pointer height.
Informational PurposesAn informational icon, calling your attention
Note
If any measurement is outside specifications, mount the vehicle on a frame bench and measure again. If the measurement is still outside of specifications, assess the damage and create a repair estimate.
Figure 1. Under Body Measurements
Figure 2. Side Body Measurements
Figure 3. Under Hood Measurements
Figure 4. Rear Body Measurements (1-Piece Cast Rear Under Body)
Figure 5. Top