2026-06-08

Cowl Top

Correction code: 10101301902 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASY - COWL TOP (Cowl Top)
2	Rivet, 4.8 mm
6	Structural Bulb Rivet, 6.5 mm
14	Flow Form Rivet S08
8	Flow Form Rivet S18

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Fender Assembly - Front - LH (Remove and Install).

Note
Remove both the LH and RH fender assemblies.
Remove the Hinge - Hood - LH (Remove and Replace).

Note
Remove both the LH and RH hood hinges.
Remove the Windshield (Non-Structural Pack) (Remove and Replace).
Remove the Airbag - Curtain - LH (Remove and Replace).

Note
Remove both the LH and RH curtain airbags.
Remove the Wiper Module (Remove and Replace).
Remove the original component.
- or Factory Spot Welds
Remove the original component.
- or Factory Spot Welds
Remove the original component.
- or Factory Spot Welds
Prepare for installation.
- or Installation Spot Welds
- or Flow Form Rivets, S08
- or Flow Form Rivets, S18
- Reference Line/Point
- or Rivets, 4.8 mm A = 17 mm B = 8 mm
Prepare for installation.
- or Structural Bulb Rivets, 6.5 mm
Prepare for installation.
- or Structural Bulb Rivets, 6.5 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform resistance spot welding.
- or Installation Spot Welds
Warning
Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.

CAUTION
Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
Perform any necessary post-repair operations.
Install the Airbag - Curtain - LH (Remove and Replace).

Note
Install both the LH and RH curtain airbags.
Install the Windshield (Non-Structural Pack) (Remove and Replace).
Install the Wiper Module (Remove and Replace).
Install the Hinge - Hood - LH (Remove and Replace).

Note
Install both the LH and RH hood hinges.
Install the Fender Assembly - Front - LH (Remove and Install).

Note
Install both the LH and RH fender assemblies.