Shock Tower Reinforcement (Vehicles Built Through February 6, 2023)
Correction code:
10101301502
10100202802
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | MY SP FUB SHOCKTOWER REINF (Shock Tower Reinforcement) |
|
| 4 |
High Strength Structural Rivet, 6.5 mm
|
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or
Factory Structural Rivets
-
Prepare for installation.
or High Strength Structural Rivets, 6.5 mm
NoteWhen fitting the Shock Tower Reinforcement, make sure that:
- The top of the Shock Tower Reinforcement is flush with the top of the Shock Tower on the Front Under Body casting.
- Any gap between the top of the Shock Tower Reinforcement and the Shock Tower of the Front Under Body casting is no more than 0.5 mm.
- Install the new component or components.
- Perform any necessary post-repair operations.