2026-11-05

휠 아치 라이너 - 전면 - LH(구조용 팩 이외)(탈거 및 교체)

교정 코드 12010902 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.

Equipment:

1133569-00-A 플라이어, 클립 탈거

토크 규격

Table 1. 토크 규격: 휠 아치 라이너 - 전면 - LH(구조용 팩 이외)(탈거 및 교체)
설명	토크 값	권장 공구	재사용/교체	참고
LH 전면 휠 라이너를 HV 배터리에 고정하는 볼트	5 Nm (3.7 lbs-ft)	10mm 소켓	재사용

탈거

Remove the LH front wheel. See #GUID-0B862D15-7178-4435-AEF2-0B40B8BEE686.
Raise vehicle fully and lower lift onto locks.
Remove the bolt and clip that attaches the LH front wheel liner to the HV battery.
5 Nm (3.7 lbs-ft)
Note
다음 공구를 사용하는 것이 좋습니다.

10mm 소켓
Remove the LH front fender garnish. .
Release the clips (x14) that attach the LH front wheel arch liner to the vehicle, and then remove the liner from the vehicle.

Note
On certain vehicles, the RH wheel arch liner is secured by clips and a screw. If a screw is present, remove it with a Torx T30 socket.

장착

장착 절차는 탈거의 역순입니다.