2026-08-09

Accélérateur (retirez et remplacez)

Code de correction 17551002 0.36 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps à taux fixe (FRT) connexe représentent tout le travail à accomplir pour cette procédure, y compris les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous. REMARQUE : Voir pour consulter les pratiques de travail sécuritaires et saines.

Retirer

  1. Remove the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).
  2. Disconnect 12V/LV power. See Alimentation 12 V/BT (déconnectez et connectez).
  3. Remove the driver knee airbag. See .
  4. Remove the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Disconnect the electrical connector from the accelerator.
    CAUTION
    If the connector locking tab is red, pull the red locking tab away from the pedal housing.
  6. Remove the bolt that attaches the accelerator to the body.
  7. Slide the accelerator downwards, and then remove the accelerator from the vehicle.

Installer

  1. Slide the accelerator up, and then install the accelerator into the bracket.
  2. Install the bolt that attaches the accelerator to the body.
    7 Nm (5.2 lbs-ft)
  3. Connect the accelerator electrical connector.
    Note
    If the connector locking tab is red: push the red locking tab towards the pedal housing.
  4. Install the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Install the driver knee airbag. See .
  6. Reconnect 12V/LV power. See Alimentation 12 V/BT (déconnectez et connectez).
  7. Branchez un ordinateur portable doté du logiciel Boîte d’outils 3 au véhicule.
  8. Run the following Toolbox routines to confirm pedal operation:
    • TEST-SELF_PMR_X_CAN-COMMSvia Toolbox:(link)
  9. Install the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).