Absorbeur de bruit - compartiment moteur - arrière (retirez et remplacez)
Code de correction
120102022.10
NOTE: Unless otherwise explicitly
stated in the procedure, the correction code and its associated FRT reflect all of the
work required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created.
NOTE: See Protection individuelle to make sure wearing proper PPE when
performing the below procedure. NOTE: See for safe and healthy working
practices.
Retirer
- Remove the rear subframe. See Châssis auxiliaire – arrière (dépose et pose).
-
Remove the clips (x6) that attach the
rear motor bay noise absorber to the body, and then remove the noise absorber from the
vehicle.
Installer
La procédure d’installation se fait en suivant l’ordre inverse de la procédure de retrait.