2026-08-09

Radhausverkleidung – Hinten – LH (Ausbauen und Ersetzen)

Korrekturcode 12011102 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Persönlicher Schutz to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

Ausrüstung:
  • 1133569-00-A Zange, Clips entfernen

    Ausbauen

    1. Entfernen Sie das linke Hinterrad. Siehe Radbaugruppe (Aus- und Einbauen).
    2. Entfernen Sie die Schraube und lösen Sie die 16 Clips, mit denen die hintere LH Radhausverkleidung am Fahrzeug befestigt ist, und entfernen Sie dann die Verkleidung vom Fahrzeug.
      5 Nm (3.7 lbs-ft)

    Montieren

    Beim Einbauverfahren werden die Schritte des Ausbauverfahrens in umgekehrter Reihenfolge ausgeführt.