2026-07-15

Wiper Module (Remove and Replace)

Código de corrección 17502502 0.30 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana (FRT) para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte para ver prácticas de trabajo seguras.

  • 2026-05-13: Added warning about pinch points on wiper module.
  • 2023-11-29: Added software reinstall step to installation section.
  • 2023-07-03: Added wiper replacement procedure to installation section.
  • 2023-06-06: Removed configuration change.

Especificaciones de apriete

Table 1. Especificaciones de apriete: Wiper Module (Remove and Replace)
Descripción Valor de apriete Herramientas recomendadas Reutilizar/Sustituir Notas
Bolts that attach the wiper module to the vehicle
7 Nm (5.2 lbs-ft)
  • 10 mm socket
 Reutilizar

Retirar

  1. Remove the cowl screen panel. See .
  2. Remove the bolts that attach the wiper module to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Se recomienda utilizar las siguientes herramientas:
    • 10 mm socket
  3. Carefully pull the wiper module towards the front of the vehicle to release the rubber anchor from the bracket on the bulkhead.
  4. Rotate the wiper module, and then disconnect the electrical connector from the wiper module.
  5. Remove the wiper module from the vehicle.

Instalar

  1. With the wiper module facing upside down, connect the electrical connector. Afterwards, rotate the wiper module towards the rear of the vehicle to ensure proper harness clearance.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Keep your fingers away from any potential pinch points and moving parts while connecting and installing the wiper module. Do not attempt to test the module until it is fully installed in the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Check the harness to make sure it is not routed incorrectly.
  2. Carefully push the wiper module towards the rear of the vehicle so that the rubber anchor inserts into the bracket on the bulkhead.
  3. Install the bolts that attach the wiper module to the vehicle.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Se recomienda utilizar las siguientes herramientas:
    • 10 mm socket
  4. Install the cowl screen panel. See .
  5. Enable Service Mode through the touchscreen. See .
  6. Perform a software reinstall. See .
  7. Run the Wiper Replacement procedure: on the touch screen, touch Service > Closures > Windows > Wiper replacement, touch Run, and allow the routine to complete.
  8. Verify the operation of the windshield washers and wipers.