2024-08-23

Accelerator (Remove and Replace)

Korrigeringskode 17551002 0.36 MERK: Hvis ikke noe annet er uttrykkelig oppgitt i prosedyren, gjenspeiler korrigeringskoden og FRT ovenfor, alt arbeidet som kreves for å gjennomføre denne prosedyren, inkludert de tilknyttede prosedyrene. Ikke stable korrigeringskoder med mindre du bli uttrykkelig bedt om det. MERK: Se Flat rate-tider for å lære mer om FRT-er og hvordan de lages. MERK: Se Personlig beskyttelse for å forsikre deg om at du bruker riktig PVU når du gjennomfører prosedyren nedenfor. MERK: Se for trygge og sunne arbeidspraksiser.

Fjerne

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  3. Remove the driver knee airbag. See .
  4. Remove the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Disconnect the electrical connector from the accelerator.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the connector locking tab is red, pull the red locking tab away from the pedal housing.
  6. Remove the bolt that attaches the accelerator to the body.
  7. Slide the accelerator downwards, and then remove the accelerator from the vehicle.

Montere

  1. Slide the accelerator up, and then install the accelerator into the bracket.
  2. Install the bolt that attaches the accelerator to the body.
    7 Nm (5.2 lbs-ft)
  3. Connect the accelerator electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the connector locking tab is red: push the red locking tab towards the pedal housing.
  4. Install the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Install the driver knee airbag. See .
  6. Reconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  7. Koble en bærbar PC med Toolbox 3 til bilen.
  8. Run the following Toolbox routines to confirm pedal operation:
    • TEST-SELF_PMR_X_CAN-COMMSvia Toolbox:(link)
  9. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).