2024-08-23

Accelerator (Remove and Replace)

교정 코드 17551002 0.36 메모: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. 메모: 아래 절차를 수행할 때 개인 보호을(를) 참조하여 적절한 PPE를 착용했는지 확인하십시오. 메모: 안전하고 건강한 작업 사례는 의 내용을 참조하십시오.

탈거

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  3. Remove the driver knee airbag. See .
  4. Remove the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Disconnect the electrical connector from the accelerator.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the connector locking tab is red, pull the red locking tab away from the pedal housing.
  6. Remove the bolt that attaches the accelerator to the body.
  7. Slide the accelerator downwards, and then remove the accelerator from the vehicle.

장착

  1. Slide the accelerator up, and then install the accelerator into the bracket.
  2. Install the bolt that attaches the accelerator to the body.
    7 Nm (5.2 lbs-ft)
  3. Connect the accelerator electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the connector locking tab is red: push the red locking tab towards the pedal housing.
  4. Install the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Install the driver knee airbag. See .
  6. Reconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  7. Toolbox 3이 설치된 노트북을 차량에 연결합니다.
  8. Run the following Toolbox routines to confirm pedal operation:
    • TEST-SELF_PMR_X_CAN-COMMSvia Toolbox:(link)
  9. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).