2026-11-06

Wheelhouse Insulator - Rear - RH (Remove and Replace)

교정 코드 15300401 15300402 FRT 0.96 메모: 절차에서 명시적으로 언급하지 않는 한 교정 코드 및 해당 관련 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 의 내용을 참조하십시오. 참고: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오. 참고: 안전하고 건강한 작업 사례는 의 내용을 참조하십시오.

경고
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-10-20: Updated the steps of removing the insulator by cutting it open.
  • 2025-12-01: Released new procedure.

탈거

  1. Open all four doors and lower all four windows.
  2. Open the liftgate.
  3. Remove the subwoofer. See 서브우퍼(탈거 및 교체).
  4. Release the clips (x2) that secure the RH body harness to the RH side trunk bulkhead.
  5. Release the RH body harness clip from the C-pillar and pull the harness backward to move it away from the body.
  6. Cut the RH rear wheelhouse insulator near the RH body harness to allow for the removal of the insulator.
  7. Remove the RH rear wheelhouse insulator from the vehicle.

장착

  1. Cut the RH rear wheelhouse insulator near the RH body harness to allow the harness to be routed into the insulator's opening hole.
  2. Install the RH rear wheelhouse insulator to the vehicle.
  3. Install the body harness back into position and secure the clip that attaches the RH body harness to the C-pillar.
  4. Secure the clips (x2) that attach the RH body harness on RH side trunk bulkhead.
  5. Install the subwoofer. See 서브우퍼(탈거 및 교체).
  6. Close the liftgate.
  7. Raise all four windows and close all four doors.