2020–2024 Model Y Service Manual

Wheels and Tires

For information on tire rotation and replacement, see 34 - Wheel and Tires.

Wheel Disposal (Rework)
Correction Code 34015007 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Parent topic: Best Practices

Model Y Service Manual
Release Notes
General Information
00 - Inspection and Service
10 - Body
11 - Closures
12 - Exterior Fittings
13 - Seats
14 - Instrument Panel
- Torque Specifications - Instrument Panel
- 1405 - Instrument Panel
15 - Interior Trim
17 - Electrical
18 - Thermal Management
21 - Infotainment
30 - Chassis
- Torque Specifications - Chassis
- 3001 - Chassis and Subframes
31 - Suspension
32 - Steering
33 - Brakes
34 - Wheel and Tires

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)>