Rear Wall Upper Crossmember Glove

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	REAR WALL UPPER CROSSMEMBER GLOVE (Rear Wall Upper Crossmember Glove)
11	High Strength Structural Rivet, 6.5 mm
3	Flow Form Rivet S18
2	Flow Form Rivet S38
1	Bolt T2K,HHN,10x38	Tesla part number 1893805-00.

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the original component.
or Factory Spot Welds
or Factory SPRs

or Bolts
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced.
or High Strength Structural Rivets, 6.5 mm
- A = 69 mm.
- B = 31 mm.
or Flow Form Rivets, S18

or Flow Form Rivets, S38

or Bolts
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Torque the bolt to 27 Nm.
Perform any necessary post-repair operations.