03/07/2024 15:58:36

Rear Wall Assembly

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds

    or Factory SPRs

    or Bolts

  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.
    or High Strength Structural Rivets, 6.5 mm
    • A = 49 mm.
    • B = 13 mm.

    or Flow Form Rivets, S18

    or Flow Form Rivets, S28

    or Bolts

  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
    Torque the bolts to 37 Nm.
  5. Perform any necessary post-repair operations.