Dash Reinforcement Assembly
Correction code:
10101029902
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY FRONT UNDER BODY COMPLETE (Front Under Body – Complete) | |
| 61 | High Strength Structural Rivet, 6.5 mm | |
| 4 | Flow Form Rivet S18 | |
| 2 | Bolt , HF,M12x35,STL[109],ZNFL,PC | Tesla part number 1089657-00. |
| 10 | Bolt , HHL,M12x43,[109],G0110,CM | Tesla part number 1882229-00. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Wet Side - HVAC (Remove and Install).
- Remove the Brake Booster Assembly (Remove and Install).
- Remove the Body Controller - LH (Remove and Install).
- Remove the Body Controller - RH (Remove and Install).
-
As a single assembly, remove the Dash
Reinforcement Assembly and the Front Body Bridge Reinforcement from the Front Under Body
Complete service part to make the new component.
-
Remove the Front Body Bridge Reinforcement Assembly.
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
or High Strength Structural Rivets, 6.5 mm
or Bolts
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Body Controller - RH (Remove and Install).
- Install the Body Controller - LH (Remove and Install).
- Install the Brake Booster Assembly (Remove and Install).
- Install the Wet Side - HVAC (Remove and Install).