C–Pillar Inner
Correction code:
10100119102
10100119202
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | ASY - C-PILLAR INNER (C–Pillar Inner) |
![]() |
33 |
![]() |
|
2 |
![]() |
Tesla part number 1851387-00. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Side Sill Insert.
-
Remove the original component.
or
Drill through factory spot welds
NoteWhen drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.or
Bolts
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
or
High Strength Structural Rivets, 6.5 mm
- A = 49 mm
- B = 19 mm
- C = 64 mm
or
Bolts
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolts as follows:
- HHL,M10x33 bolts, part number 1851387: 90 Nm.
- Install the Side Sill Insert.
-
Install the fasteners as indicated.
or
High Strength Structural Rivets, 6.5 mm
- D = 12 mm
- E = 6 mm
- F = 8 mm
- Perform any necessary post-repair operations.