2026-07-09

Rear Wheel Arch (Rear Section)

Correction code: 10102000102 10102000202 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
Properly mount the vehicle on a frame bench when performing this procedure.

Parts List


Quantity	Description	Image / Notes
1	ASY WHEEL ARCH (Rear Wheel Arch)
4	High Strength Structural Rivet, 6.5 mm
5	Rivet, 4.8 mm
2	Countersunk Rivet, 4.8 mm Long

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Wheel Assembly (Remove and Install).
Remove unnecessary components from the service assembly.
Remove the necessary portion of the Mast Assembly (Section) to expose the underlying component being replaced.
Remove the original component.
or Factory Spot Welds
or Drill through factory spot welds
Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.

Reference Line/Point
or High Strength Structural Rivets, 6.5 mm
- A = 98 mm
- B = 185 mm
- C = 11 mm
Note
The installation spot weld location may vary in the area circled in red, so the fastener must be placed in the location specified by the measurements.
or Rivets, 4.8 mm

or Countersunk Rivets, 4.8 mm Long
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the portion of the Mast Assembly (Section) that was removed to expose the component being replaced.
Install the fasteners as indicated.
Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
or High Strength Structural Rivets, 6.5 mm
- D = 246 mm
- E = 62 mm
Perform any necessary post-repair operations.
Install the Wheel Assembly (Remove and Install).