Rear Under Body (Complete)
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
- The Rear Under Body is a single component, and can be replaced as a single repair. Alternatively, instead of replacing the complete Mast Assembly, the LH or RH side of the Rear Under Body can be replaced using a Rear Under Body Half Section service part and the top and bottom reinforcement plates described in the Rear Under Body (Section) procedure.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | ASY REAR UNDERBODY (Rear Under Body) | |
4 | PLUG |
Tesla part number 1870761-00. |
10 | High Strength Structural Rivet, 6.5 mm | |
6 | Bolt BLT,HHL,M10x33 | Tesla part number 1851387-00. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
On the original component,
verify the location of the center point for the rear-most access hole.
The center point for the rear-most access hole should be located 155 mm to the rear of the indicated hole (measurement A).NoteIf the center point marked on the component is 150 mm, move the center point 5 mm to the rear of the marked center point (measurement B).
- On the original component, cut the rear access holes.
- Detach the original component from the surrounding panels.
-
Bulk cut and remove the original component.
Cut the Rear Under Body near the C-Pillar Inner area as shown, then remove the cut portion of the original component.NoteTo prevent damage to the C-Pillar Inner, when cutting near the inboard side of the C-Pillar Inner, cut only in the area shown in yellow (do not cut in the area shown in red).
-
Remove the remaining portion of the original component.
Use heat and separation methods, then grind as necessary to remove the remaining casting material (shown in red) near the C-Pillar Inner area.NoteUse caution to make sure that the C-Pillar Inner is not damaged when removing the remaining portion of the original Rear Under Body casting.
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
or High Strength Structural Rivets, 6.5 mm
or Bolts
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolts to 90 Nm.
-
Install the plugs to cover
the access holes.
NoteApply seam sealer to the bottom side of each plug before installation, and remove any visible seam sealer around the outside edge of the plug after installation.
-
Trim the Rear Rocker Step
Reinforcement to allow clearance for the plug that covers the rear access
hole.
NoteRemove any visible seam sealer from around the access hole plugs that would be under the foam gasket of the Rear Rocker Step Reinforcement.
- C = 7 mm.
- D = 32 mm.
- Install the Tailgate Tower.
- Perform any necessary post-repair operations.