2025-10-15

Rear Wheel Arch

Correction code: 10102000302 10102000402 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
Properly mount the vehicle on a frame bench when performing this procedure.

Parts List


Quantity	Description	Image / Notes
1	ASY WHEELHOUSE ARCH (Rear Wheel Arch)
4	High Strength Structural Rivet, 6.5 mm
5	Rivet, 4.8 mm
2	Countersunk Rivet, 4.8 mm Long

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the necessary portion of the Mast Assembly (Section) to expose the underlying component being replaced.
Remove the original component.
or Factory Spot Welds
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced.

Reference Line/Point
or High Strength Structural Rivets, 6.5 mm
- A = 90 mm
- B = 185 mm
- C = 11 mm
Note
For the area circled in red, spot weld locations may vary, so the fastener must be placed as specified.
or Rivets, 4.8 mm

or Countersunk Rivets, 4.8 mm Long
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the portion of the Mast Assembly (Section) that was removed to expose the component being replaced.
Install the fasteners as indicated.
Reference Line/Point
or High Strength Structural Rivets, 6.5 mm
- D = 246 mm.
- E = 62 mm.
Perform any necessary post-repair operations.