2025-06-13

Sensor - Wheel Speed - ABS - Front - LH (Remove and Replace)

Correction code 33100502 0.30 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.
  • 2024-06-06: Updated the wheel speed sensor bolt from a one-off bolt to a reusable one, and added the torque specification table.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Os vídeos incluídos neste procedimento destinam-se a ser utilizados como uma visão geral apenas para efeitos complementares. Siga todos os passos enumerados no procedimento para evitar danos nos componentes e/ou ferimentos.

Remove

  1. Remove the front LH wheel. See #GUID-0B862D15-7178-4435-AEF2-0B40B8BEE686.
  2. Remove the LH front fender garnish. See .
  3. Remove the clips that attach the front of the LH front wheel arch liner to the vehicle, and then pull the liner rearward for clearance.
  4. Disconnect the electrical harness from the front LH ABS wheel speed sensor connector.
  5. Release the clips and remove the grommet that attach the front LH ABS wheel speed sensor to the body and front LH suspension.
  6. Remove the bolt that attaches the front LH ABS wheel speed sensor to the knuckle, and then remove the sensor from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket

Install

  1. Install the front LH ABS wheel speed sensor to the knuckle, and then install the bolt that attaches the sensor to the knuckle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
  2. Fasten the clips (x4) and install the grommet that attach the front LH ABS wheel speed sensor cable to the body and front LH suspension.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Perform a push-pull check on each clip and the grommet to make sure they are fully attached to the body, to the upper control arm, and to the knuckle.
  3. Connect the electrical harness to the front LH ABS wheel speed sensor connector.
  4. Position the LH front wheel arch liner onto the front fascia, and then install the clips that attach the liner to the vehicle.
  5. Install the LH front fender garnish. See .
  6. Install the front LH wheel. See #GUID-0B862D15-7178-4435-AEF2-0B40B8BEE686.
  7. Perform a test drive that includes a minimum speed of 25mph in straight line for at least five seconds to allow the ESP internal system checks to complete. The ESP faults will clear if the vehicle is repaired correctly. If faults are persistent after the test drive, continue troubleshooting the repair.