2026-05-12

Sill Plate - Front - LH (Remove and Replace)

Correction code 12051102 0.12 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

Equipamento:
  • 1049517-00-A Seam Roller, Silicone, 5"

Remove

  1. Open the LH front door.
  2. Use IPA wipes to clean around the sill plate.
  3. Apply masking tape around the perimeter of the sill plate to mark the installation positioning.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place the tape as closely around the sill plate as possible.
  4. Use a plastic trim tool to carefully pry up and bend the sill plate.
  5. While using pliers to pull up on the sill plate, use a retractable blade to cut through the adhesive.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To reduce the risk of personal injury, wear cut-resistant gloves while performing this operation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the vehicle trim or body.
  6. Use IPA wipes to clean off any remaining adhesive.

Install

  1. Remove the adhesive backing from the new sill plate.
  2. Using the masking tape as a guide, carefully place the new sill plate into place and press down on it to adhere it to the vehicle.
  3. Use a seam roller to fully wet out the adhesive.
  4. Remove the protective film from the sill plate.
  5. Remove the masking tape from the door sill.
  6. Close the LH front door.