2026-07-20

Door - Front - LH (Remove and Install)

Código de corrección 10106001 0.42 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana (FRT) para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte para ver prácticas de trabajo seguras.

Retirar

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  4. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  5. Remove the middle A-Pillar trim panel. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  6. Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  7. Disconnect the LH front door electrical connectors from the LH body controller module.
  8. Release the electrical harness clip from the LH body controller module.
  9. Release the grommet, and then push the LH door electrical harness through the A-pillar bulkhead.
  10. Remove the bolt that attaches the LH front door check strap to the A-pillar.
    24 Nm (17.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Unbolting the door check allows the door to swing freely beyond opening limits.
  11. Use tape to mark the mounting locations of the door hinges on the LH front door.
  12. Loosen the hinge bolts, and then remove the lower bolts for each hinge.
    24 Nm (17.7 lbs-ft)
  13. Partially unthread the upper bolt for each hinge, and with assistance, lift the LH front door away from the vehicle.

Instalar

Informational PurposesAn informational icon, calling your attention
TIp
For instructions on how to align the front door, refer to .

El procedimiento de instalación es inverso al de desmontaje, excepto en lo siguiente:

  • Partially thread the upper bolt for each hinge in the door so that the door can set on the hinges to install the lower bolt.
  • Apply touch up paint to painted fasteners that were removed and reinstalled during this procedure.