2024-08-23

Acelerador (Desinstalación y sustitución)

Código de corrección 17551002 0.48 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana (FRT) para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte para ver prácticas de trabajo seguras.

Retirar

  1. Remove the 2nd row lower seat cushion. See Cojín del asiento - Parte inferior - 2.ª fila (Desinstalación y sustitución).
  2. Remove the rear underhood apron. See Faldón del vano del motor - Parte trasera (Desinstalación y sustitución).
  3. Disconnect 12V/LV power. See Alimentación de 12 V/baja tensión (Desconexión y conexión).
  4. Remove the driver knee airbag. See .
  5. Remove the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  6. Disconnect the electrical connector from the accelerator.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the connector locking tab is red, pull the red locking tab away from the pedal housing.
  7. Remove the bolt that attaches the accelerator to the body.
  8. Slide the accelerator downwards, and then remove the accelerator from the vehicle.

Instalar

  1. Slide the accelerator up, and then install the accelerator into the bracket.
  2. Install the bolt that attaches the accelerator to the body.
    7 Nm (5.2 lbs-ft)
  3. Connect the accelerator electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the connector locking tab is red: push the red locking tab towards the pedal housing.
  4. Install the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Install the driver knee airbag. See .
  6. Reconnect 12V/LV power. See Alimentación de 12 V/baja tensión (Desconexión y conexión).
  7. Conecte un ordenador portátil con Toolbox 3 al vehículo.
  8. Run the following Toolbox routines to confirm pedal operation:
    • TEST-SELF_PMR_X_CAN-COMMSvia Toolbox:(link)
  9. Install the rear underhood apron. See Faldón del vano del motor - Parte trasera (Desinstalación y sustitución).
  10. Install the 2nd row lower seat cushion. See Cojín del asiento - Parte inferior - 2.ª fila (Desinstalación y sustitución).