Installing Front Trunk Lighting (2020-2024 Model Y)
Note
Depending on market region, vehicle configuration, and date of manufacture, this accessory
may not be available for your vehicle. Accessories are available for purchase online at
www.tesla.com (or http://www.tesla.cn, depending on region).
- Open the front left door and fully lower the front left window.
- Open the hood.
- Release the clips that attach the access
panel to the front trunk, and then carefully pull the panel away from the vehicle.CAUTIONDo not completely remove the panel as a harness is still connected to it.NoteGrab the panel from the top, and then carefully pull it rearward to release the clips.
- Disconnect the emergency release switch
connector.
- Remove the adhesive backing from the front
trunk lighting module, and then install the module to the area indicated in the image,
ensuring it is properly oriented as shown. Once aligned, apply pressure along the module to
ensure it is adhered to the access panel.NoteUse IPA wipers to clean the installation area in the access panel and allow 1 minute to dry.
- Connect the vehicle harness side connector
(1), the front trunk lighting module connector (2) and the emergency release switch
connector (3).
- Align the guide tabs, and then install the
clips that attach the access panel to the front trunk.
- Press the emergency release switch and make
sure that there is an audible click. Repeat this step to ensure that there is a click after
each press.
- Use a plastic trim tool to open the front
trunk seal, and then insert the front trunk lighting strip in a clockwise direction. Make
sure the strip is snug to the inside of the seal.
- Close the hood.
- Raise the left front window and close the left front door.